Stream Alerts: Configuring Field Settings

Configuring Field Settings

Introduction

The purpose of the stream alerts feature is to set alert limits on the streams and sample locations in Validere 360. In this article, field measurement alerts for samples that have been taken from the field and have been tested in either a field lab or in a third party lab will be discussed.

Configuring Off-spec Alerts

To configure off-spec alerts find the stream(s) that you are interested in using the search bar. You may select more than one stream for configuration. Next click on the dash (if no existing limit exists) or the number corresponding to the property that you would like to configure. A pop-up will appear in which the desired off-spec limits can be specified.

Configuring Statistical Limits

To configure statistical alerts find the stream(s) that you are interested in using the search bar. You may select more than one stream for configuration. Next click on the dash (if no existing limit exists) or the number corresponding to the property that you would like to configure. A pop-up will appear in which the desired statistical limits can be specified.

Deleting Alert Limits

To delete existing alert limits, select the desired streams and then click on the corresponding property for which you would like to remove existing limits. Once the pop-up appears, simply leave the fields blank and click 'Update'.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Get Support Get Support