Bulk Calculations

Introduction 

Performing bulk calculations is simple in the Validere platform. There are two ways to run calculations on your estimation methods:

  1. Emissions calculations page: contains all the estimation methods on equipment 
  2. Volumetric calculations page: contains all the estimation methods on flows

Bulk Apply Configuration

To apply input sourcing, filter to a set of calculators that you want to work on. Once you have a list of calculations, you can select individual rows to apply configuration or apply estimation method configuration to the whole set. If you have more than 25 rows in your set, you will get a modal asking for confirmation.

  1. Click on Calculations under the Emissions or Volumes page in the Navigation bar. 
  2. Filter. 
  3. Click Apply Configuration. A confirmation window will pop up if more than 25 rows are selected. 
  4. Once configuration has started, aprogress bar will appear.
  5. Wait for configuration to finish being applied.

Bulk Calculate

To bulk calculate, filter calculations with a  “Pending” status. Calculations with a “Missing Inputs” status will not be included in your calculations. Once you have a list of pending calculations, you can select individual rows to calculate or calculate the whole set. If you have more than 25 rows in your set, you will get a modal asking for confirmation.

Note: 10,000 calculations can take up to 60 seconds to execute.

  1. Click on Calculations under the Emissions or Volumes page in the Navigation bar. 
  2. Filter to pending calculations by clicking on the “Search Status” bar and selecting “Pending”. 
  3. Click “Calculate”. A confirmation window will pop up if more than 25 rows are selected. 
  4. Once calculation has started, a progress bar will appear.
  5. Wait for the calculations to finish executing.